- 3d Finish toolpath leave slight mark
-
Registered
-
-
Registered
Re: 3d Finish toolpath leave slight mark
This looks like cutter deflection caused by the tool moving in opposite directions. Reduce your depth of cut on the finish pass and this effect will be reduced. This is a typical example of 'conventional' vs 'climb' cutting. There isn't anything wrong with your software or hardware, it's machining technique.
- 3d Finish toolpath leave slight mark
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules