3d Finish toolpath leave slight mark


Results 1 to 2 of 2

Thread: 3d Finish toolpath leave slight mark

  1. #1
    Registered
    Join Date
    Feb 2016
    Posts
    22
    Downloads
    0
    Uploads
    0

    Default 3d Finish toolpath leave slight mark

    Hello


    I use Aspire 8.5 to milling out this,look at the picture and you will see 5 slight mark after 3d Finish,these slight mark should not be there.


    I wonder,What can be wrong ?

    Aspire software,Settings in Mach3 or CNC Router machine

    Similar Threads:
    Attached Thumbnails Attached Thumbnails 3d Finish toolpath leave slight mark-aspire-8-5-3d-finish-toolpath-leave  


  2. #2
    Registered
    Join Date
    Feb 2009
    Location
    USA
    Posts
    192
    Downloads
    0
    Uploads
    0

    Default Re: 3d Finish toolpath leave slight mark

    This looks like cutter deflection caused by the tool moving in opposite directions. Reduce your depth of cut on the finish pass and this effect will be reduced. This is a typical example of 'conventional' vs 'climb' cutting. There isn't anything wrong with your software or hardware, it's machining technique.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

3d Finish toolpath leave slight mark

3d Finish toolpath leave slight mark