- Could I use an Arduino Pro Micro with the ADS1115 to build a joystick?
-
Member
Could I use an Arduino Pro Micro with the ADS1115 to build a joystick?
Hello, I have a question. Could I use an Arduino Pro Micro (10bit resolution) with the ADS1115 (16bit resolution) to build a joystick (with better sensivity) that uses some hall effect sensors with magnets ? Thank you !
Similar Threads:
-
-
Member
Re: Could I use an Arduino Pro Micro with the ADS1115 to build a joystick?
The ADS1115 can be powered at 5V and uses i2c to communicate so it should work without any doubt.
I don't think 12 bit resolution will do a better job because 10 bits resolution are 1024 steps. I doubt if your (a) hand is capable of moving the joystick so little that 10 bits resolution isn't enough.
- Could I use an Arduino Pro Micro with the ADS1115 to build a joystick?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules