Aurdino and cnc shield clone axis reversing steppers

Results 1 to 3 of 3

Thread: Aurdino and cnc shield clone axis reversing steppers

  1. #1
    Member
    Join Date
    Feb 2005
    Location
    Australia
    Posts
    53
    Downloads
    0
    Uploads
    0

    Default Aurdino and cnc shield clone axis reversing steppers

    Hi everyone,

    I am making a 100W CNC laser.

    I will be using 2 steppers on the x axis so have cloned x an a with the jumpers.

    I don't seem to be able to get the second motor to run in he opposite direction to the x axis.

    any help would be appreciated.

    Thanks

    Prboz



  2. #2
    Member routalot's Avatar
    Join Date
    Dec 2003
    Posts
    1206
    Downloads
    0
    Uploads
    0

    Default Re: Aurdino and cnc shield clone axis reversing steppers

    Find the direction cables and swap the connections?I don't know too much about Arduino based systems,but if the same number of pulses are going to the steppers,it seems to be the logical thing to correct the direction problem.Just don't try it at the extreme ends of travel and only test with a very small movement.



  3. #3
    Member
    Join Date
    May 2005
    Location
    canada
    Posts
    1662
    Downloads
    0
    Uploads
    0

    Default Re: Aurdino and cnc shield clone axis reversing steppers

    If it's the common Protoneer type shield just rotate the motor connector 180 degrees. The shield shown in link below:
    Arduino Compatible CNC Shield Instructions

    I know this works because I've done this myself but the usual advice is to reverse one set of coils (phase). I found an explanation of why it works on another forum:
    Actually reversing the plug does reverse both coils, but also swaps the coils over, so it does reverse the motion.
    I.e. you can reverse either coil to reverse it, or you can swap the coils over. Doing all three will also reverse, which is what happens if you fit the plug backwards.
    And to give due credit, a link to where it was posted:
    https://reprap.org/forum/read.php?12...1178#msg-31178

    EDIT>>> It just dawned on me you may not be using the little step-stick drives that plug-in that shield. If using external drives rotating a motor connector may be bad advice

    Last edited by cyclestart; 07-10-2020 at 04:00 AM.
    Anyone who says "It only goes together one way" has no imagination.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Aurdino and cnc shield clone axis reversing steppers

Aurdino and cnc shield clone axis reversing steppers