PDA

View Full Version : Need Help! Torch Shutting Down



IHscout
01-31-2010, 02:16 PM
I have a little problem with my plasma torch shutting down for some unknown reason. It will only do it part of the time. When it does shut down the status bar in Mach 3 says that the PWM bumped to minimum setting. I have tried adjusting the %, but no help. Do I need to run it with the PWM control or step/dir motor, these are the two options under spindle control.

Guys I need help before I take a HAMMER to it. Well maybe I wont take a hammer to it, but it is pushing my buttons.

:confused: