PDA

View Full Version : Need Help! DMU 50 evolution



sguru007
12-19-2009, 12:04 PM
Hi

Could any body tell me if we could buy dmu 50 evolution machine in case we are planning for impeller machining and blisk machining.

Thanks

bcat1
12-23-2009, 02:35 PM
Yes you can do both, but also depends on material. They have other machines that do this work just as well.

sguru007
12-24-2009, 10:56 PM
Hi

Material is going to be Titanium

Thanks

bcat1
12-29-2009, 03:44 PM
Titanium will not be a problem. If you are ordering make sure of scales in xyz, probe and laser tool setter for best accuracies. Machine comes standard with 18,000 RPM spindle, it has a high tourque rating and plenty of HP. HSK 63 tooling is a must at the higher RPM, althought a bit more expensive, it is a better balanced holder than CT or BT.. GOOD LUCK