PDA

View Full Version : Vacuum router bed



speedracer
06-17-2003, 11:30 AM
Does anyone know of a good vacuum router bed design. I don't consider Carter pods a good design. ( in some ways it's ok ) I have designed a table myself and it has been in use for about 6 years now and it works ok. What i am really looking for is some advance ideas for shutting vacuum on and off on the table port holes. Pods that i use have no hoses attached to them. All the vacuum is thru the table. The table has many holes that are now plug with rubber plugs.

I hope this kinda makes sense.

HomeCNC
06-17-2003, 01:25 PM
This sounds like the vacuum table I am making right now. Check out my post in the wood router section on the vacuum clamping post.

HuFlungDung
06-17-2003, 02:11 PM
There is a bit of a discussion going on here:

http://cnczone.com/showthread.php?s=&threadid=618