PDA

View Full Version : Maho MH 600 E2, communication



jeuhrn
10-12-2009, 05:55 AM
Does anybody have a computer communications setup on this type, or similar mill?

In the patching cabinet on the back of the machine there's 1 RS232C port, but there's a cable in it that's wired in with a bunch of others and disappears into the machine. It does not look like a cable to be removed, unless it ends up in a RS232 contact elsewhere on the machine (I've looked and I can't find anything).

Below the RS232 there are two empty female 9-pin ports labeled RS449.

Any tips?