PDA

View Full Version : Need Help! DECKEL FR4A 1987 CONTOUR 2 CONTROLLER



terminator
09-15-2009, 03:37 PM
HI EVERYONE THANKS FOR GREAT REPLIES.
MY DECKEL FP4A MILL HAS GOT A CONTOUR 2 CONTROLLER
3 AXES 2 1/2 D MILLING. I GOT A POST PROCESSOR FROM
DOLPHIN CAM BUT DID NOT GET THE INTERFACE CABLE WITH
THE MACHINE. THE ONLY CABLE IS STERIO JACK TYPE THAT I
CAN PLUG INTO A TAPE RECORDER.
CAN SOME ONE HELP ON WERE I CAN GET A CABLE TO CONNECT
TO MY COMPUTER AND WILL OTHER CAM PROGRAMS ALSO WORK
ON DOLPHIN CAM POST PROCESSOR.
MY CONTROLLER,S MEMORY IS VERY SMALL 24K I THINK.
IS THERE A WAY AROUND THIS TO SAVE LARGER PROGRAMS
ON MY HARD DRIVE AND MACHINE FROM THERE.

IS THERE SOME ONE WHO CAN HELP ME TO MAKE UP MY OWN CABLE
IF POSSEBLE.

THANKS
REGARDS
TERMINATOR