PDA

View Full Version : Spindle orientation parameter



Hagrid
09-10-2009, 03:19 PM
Greetings to all!
I'm new here.
DMU50T with Mill Plus control.
I had to put a new encoder in the spindle motor and now I am looking for the constant that controls the spindle orientation during a tool change.
I know that ...
X axis
3145 Homeposition 1 Pre-Position
3146 Homeposition 2 Tool Change Position
Y axis
3245 Homeposition 1 Tool Change Position
Z axis
3345 Homeposition 1 Tool Change Position
3346 Homeposition 2 Pre-Position
I'm guessing based on this the spindle orientation is 3x45 or 3x46 but what number goes where x is?
If no one knows, Ill just have to play with it.
Thanks,
Hagrid.