PDA

View Full Version : g-codes



pimp215
03-05-2005, 05:49 PM
where can i get a complite list of g-codes

Al_The_Man
03-05-2005, 05:52 PM
Do a forum search like this one http://cnczone.com/forums/showthread.php?t=8183&highlight=codes
Al

pimp215
03-05-2005, 05:58 PM
thank you. but I tried that and I'm looking for the whole list like what g-07, or g-150.

murphy625
03-05-2005, 06:34 PM
Do a forum search like this one http://cnczone.com/forums/showthread.php?t=8183&highlight=codes
Al

Which returns the following result

http://www.camaster.com/camaster/gcode_list.htm

Just had to scroll down a few ...

Is that what your looking for?? No G150 in there that I could find though...

Hope that helped.
Murphy

Al_The_Man
03-05-2005, 07:20 PM
g150 is covered in the Haas mill list at http://www.haascnc.com/training/MillProgram_PDF/Mill%20G%20and%20M%20Card.pdf
Al

DAB_Design
03-05-2005, 07:46 PM
Anything that you can't find in a generic list online, is more than likely a proprietary code for a certain controller. For instance, some of our machines (cincinnati milacron) can use a G181 which is a 5 axis drill peck cycle.

pimp215
03-06-2005, 01:41 AM
ya thanx the machines are 40-m, and 40-e made by fanuc

gibbsman
03-06-2005, 05:08 AM
Forgive me if I'm wrong, but you or your company should have manuals for the machines that you need to work on on and they will have a list of 'M' and 'G' codes applicable to that machine.

pimp215
03-06-2005, 01:57 PM
true, they do but the guy that is teaching me how to mill tells me that there is more. And I'm sorry but its not Fanuc that make the machines its Mori Sieki (I'm new to the trade)

cadman
03-06-2005, 03:10 PM
true, they do but the guy that is teaching me how to mill tells me that there is more.
There is more, but if the machine builder does not have them listed in your manuals they will not work on your machines. They will just generate alarms if you try to use them. There are codes unique to particular controllers, machines and options that may not be installed on your machines.

RJT
03-07-2005, 03:53 AM
Look at the back of your Zeus book . Different machines have different assigned g and m codes . generally speaking though they are fairly similar. I use mastercam these days .

pimp215
03-07-2005, 02:43 PM
thank you you guys have been a lot of help but whats a my zeus book? Is that my manual?