PDA

View Full Version : Need Help, Acramatic 2100



acra2100
08-26-2009, 11:14 AM
I am having a lot of problems with my yr 2000, Mighty, Mustang C32 mill.
I have to switch the machine on and off 2 or 3 times for it to get by
"insert bootable media" on the first screen. It will eventually get by but
will take 20 minutes to load ( I have to press ok on a timeout message
at least 6 times during load). Once up and running navigation between
different functions such as setup and edit etc is extremely slow. Data
reset takes about 8 seconds as do tool touchoffs. If I dont let a function
such as data reset fully cycle before entering another command it seems
to plug things up and the machine will crash to a blue screen with a lot of
codes and other writing on it, I have to switch off power and begin the entire
process over again. Once I get the machine up and program in it functions
but is a little slow when tapping. I am getting desparate, any info would
be appreciated.

aiping9
10-07-2009, 05:15 AM
Hi, it seems that poor connection exist between hard disk and power supply module or main board. Suggest to replace the flat cable connecting the main board and to clean every pins completely of the plug of the power supply module. Feel free to contact wu_aiping9@hotmail.com.