PDA

View Full Version : Need Help! Four axis Controller Mach3 Configure+Wiring



winattitude
08-09-2009, 03:15 PM
Hi everyone,

I got the 4-axis board and motor drivers from sunrom here in India.

I have attached two images 1) 4-axis board 2) stepper motor driver for 1 motor, I have four of them (4 boards and 4 motors), Also I have attached the schematics of each one

I was able to complete all the connections on my own, however I am able to control the motors partially through PC.


Driver Board ..........4-axis Board
EN.........................EN
DIR........................DIR
CLK......................STEP
GND......................GND

But cannot understand where should I connect
HOME
HALF/FULL
RST
OSC

How to include Limit Switch And E stop
I have bipolar motor with 4 wires 12v

I need help ....please reply asap

winattitude
08-10-2009, 02:00 PM
Someone Please Help!!

I have brought these boards and now I unable to get it working.The Supplier of these board(Sunrom) is not responding to my repeated request.

Troelli
08-27-2009, 03:12 AM
hmmm ... all what your a looking for is written in your Manuals you have attached.