PDA

View Full Version : looking for options



chunkymonkey
07-10-2009, 11:19 AM
i have a citizen m2-30/32. kinda wondering if anybody knew how to turn the full c axis option on for the sub spindle. or is there a site to find it myself? thanx

ProProcess
07-11-2009, 08:09 AM
Pay for it

PixMan
07-11-2009, 06:40 PM
Pay for it

Pretty much sums it up. Your machine may need much more than just illegally turning on an option in the control. It may need a completely different spindle drive control and motor, among other things.

Shadow_CMA
07-16-2009, 11:21 AM
I could tell you, but then I'd have to kill you, and anyone you may have talked too.
You know "company secrets," there was 2 differnet ways of turning options on the M2 series machines, the proper way is to PAY your distributor to turn it on in the MC-STRUCT page (using a special code).
The cheating way is to turn it on is typing in a special access code in the PLC/IF page, then going to MAINT., S/W LIST, and look for the OPTIONS page, it requires a hexidecimal code on the Mitsubishi Option page, but if you enter the wrong code you'll turn your machine into a paperweight.

Shadow
CMA Service