PDA

View Full Version : Need Help! DECKEL FP5-80 CNC Machine



mohsin_qau
07-06-2009, 10:37 AM
To all CNC Maintenance Engineers!!!

Hope all u well......

I have a problem with FP5 CNC Machine .......This M/C successfully complete its contour job with X-axis and Y-axis. But when it goes at center .......its become flat of 10um at both edges.....

Plz help me out that problem

Regards

Mohsin Hayat
Maintenance Engineer

ASSK
08-31-2009, 07:41 AM
Dear Mr. Mohsin Hayat

I have also same machine in Pakistan. It is possible to confirm your address/Company

ASSK/Shariq
shariq@asskmachinery.com


To all CNC Maintenance Engineers!!!

Hope all u well......

I have a problem with FP5 CNC Machine .......This M/C successfully complete its contour job with X-axis and Y-axis. But when it goes at center .......its become flat of 10um at both edges.....

Plz help me out that problem

Regards

Mohsin Hayat
Maintenance Engineer