PDA

View Full Version : Need Help! Fanuc-OMC workoffsets



KCA324
06-28-2009, 12:44 PM
I need help, I can't seem to find where to insert the workoffsets in the controller. I know this sounds stupid. In the offsets there should be, in the sub-menu, a (Work) label beside the (Offset) but there isn't one. Does this machine use absolute only or is their something that has been changed in the parameters? Maybe a there's a parameter that truns it on and off? The only offset I can find is the Tool offset.

Any help would be great! Thanks!

elmor fudd
11-19-2009, 05:35 PM
Sounds like your restricted to G92 only but this can be change by parameters to give you G54 to G59 but you have to pay Fanuc:rolleyes: