PDA

View Full Version : Need Help! Centroid Driver Boards



beamsjr
06-04-2009, 01:43 PM
I have a centroid encoder and driver boards from an old cnc router and I am curios if i might be able to use the driver boards some how with a breakout board. Do these boards use step and dir signals from the encoder? If they do how would I figure out what pins are what?

Here is a link to one of the driver boards...

http://www.flickr.com/photos/38074740@N03/3595923448/in/set-72157619243987528/

If not is this stuff worth anything? Should I just toss it?

Thanks, Joe