PDA

View Full Version : NcPlot sub call



patcareyis
05-24-2009, 07:00 PM
I'm having a problem with ncplot calling subs listed as M98(C:\filename.nc)
Seems as though it interprets ( ) as note I have tried changing notes to [] but no help is there a way around this through a macro or something else or is this limitation of the current software.

MetLHead
05-24-2009, 09:19 PM
Hi,

NCPlot can not call an M98 sub program directly from the file name like that. It expects to see a program number in the format M98 P1234 where "1234" is the program number. Actually, it can recognize a few different variations on that format but it always expects to see a program number. The subprogram setup page (under the Setup menu) also can be used to assign a file to a specific program number.

Thanks,
Scott