PDA

View Full Version : Need Help! driver



MR MOTION
04-16-2009, 11:02 PM
BobCAD – CAM

I am a newbie and looking for information.
a. I have a BobCad Cam program I am missing the hardware from the code to the motors. I am looking for “driver schematics” in which I could build the drivers.
b. I happen to have the Arrick robot MD2 dual stepper motors which are presently driving my stepper motors. Is it possible to reconfigure these drivers to accept “g” code or to use part of these drivers in conjunction with different hardware to accept “g” code?


I look forward to any input you may supply.

hdmechno1
11-14-2009, 11:45 PM
i,m a newbie also and i can't help ya with your question. but i also have an md-2 system but no software. so i was wondering what you were using for your and if you would like to pass a copy along?
thanks