PDA

View Full Version : Where to find Shell mill / Face mill arbor for taig



725franky
02-26-2009, 09:02 AM
Does anyone know where I could find a shell mill / face mill arbor for my taig?

Or does everyone just stick with using a fly cutter for surface finish?

Thanks,

Frank

MLP F1
02-27-2009, 06:35 AM
There was one once But when I found it the link didn't work any longer.

http://www.cartertools.com/spill.html

Marty

rowbare
02-27-2009, 02:04 PM
DeArmond Tool http://www.positiveflow.com/taigacc.htm has had one in the past though I don't see them listed there anymore.

You might call or email them to see if they still carry them or can point you to their source.

Odin
11-16-2009, 03:38 PM
No one knows anyone that carries a face/shell mill for the Taig? Can anyone point out a shell mill of Taig size, that would work if I had to make an adapter?

I really need one of these. I need to surface large blocks of steel, aluminum, and 360 brass. Can anyone think of something I could use???

725franky
11-18-2009, 09:00 AM
I believe that if you were to make an adapter you could use one of these shell mills: Enco Shell Mill (http://www.use-enco.com/CGI/INSRIT?PMAKA=320-4020&PMPXNO=947702&PARTPG=INLMK3)

ee_t
11-18-2009, 05:48 PM
Taig er16 1/2" end mill holder (https://www.a2zcorp.us/store/Category.asp?Cguid={C1265C09-587A-4F42-9864-4C41CBD46A48}&Category=EndMillHolder%3AER16)
+
Shars 1/2" shank shell mill arbor (http://www.shars.com/products/view/880/12x34quot_Shell_Mill_Arbor)
+
http://www.shars.com/products/view/7845/212_90_degree_Face_Mill_APKT_Insert
or
http://www.shars.com/products/view/7879/2_Round_Indexable_Face_Mill_RPMT_Insert
or
anything on ebay/etc. that uses the same 3/4" mounting method.


Don't know how long this ends up being. You could cut the arbor, or combine the first two items and make them yourself I suppose.