PDA

View Full Version : Need Help! Liquid sand blast stencul mask



graver1
02-12-2009, 01:14 AM
I would like to find a material that can be brushed or sprayed, to use on glass, ceramic, metals or stone. I would use a lowpower laser to burn the graphics and the stencil would resist the sand blasting until I removed it with heat or solvent. This is for uneven surfaces. So far Nail polish shows some promise, but does not burn away completly. Same w/ wax, liquid tape, spray enamel, rubber cement.
There is a coating that will leave a mark from the laser, but I want it deeper and I dont have a hi power laser. Any Ideas? LL.

LaserImage
02-12-2009, 01:09 PM
Try plasti-dip. I tried it a couple of years ago and it worked pretty well. You will need to put it on pretty thick, but it comes off pretty easily.

Gary