PDA

View Full Version : Newbie just to say Hi



mikefin
02-07-2009, 09:13 AM
Hello everyone I'm new here. I've been working on Tornos and Strom
single spindle cam machines for the last 14 years.
The company I was working for sold out in Sept. of last year.
So I have started back to school to learn CNC programing and to set-up and opperate cnc mills and lathes.
If I can help someone with questions about cam machines I will be glad to help.

dali_290
11-14-2010, 01:46 PM
Hello .

I am looking for someone who can hepl me with programming machine Tornos ENC 167 .
I need to know very urgently how to program synchronization of C axis for
both spindles during cutting off.
There is Fanuc 16 TB system.
I need to drill some cross holes in S1 and then next cross ones in S2
spindle. These holes have to be in exact angle position each other. So
when I cut off the part then I have to ensure that the part in S2 spindle
will be in know angular position. Without this is impossible to drill
holes in S2 so that they will be in exact angular position towards holes
made in S1 .
My programming manual is not complet as there is only very short mention
about macro G355.
My problem is that I do not know how to use macro G355 with variable D.
Maybe you know how to do that and could hepl me.

Thanks in advance

reg.

Dali