PDA

View Full Version : Some help from Kong.



MrBean
11-27-2004, 11:05 AM
I've been looking back over the post of Kong building his router and noticed the pic of machining out the brackets for the Makita RF/RD-1101.

I have orderd one and am waiting for it to arrive. I was wondering if you'd be willing to share the file used to cut the parts. .dxf or 3D part file. If you still have them?

Regards Terry...

kong
11-27-2004, 12:09 PM
No probs, I have posted the file before, shuld put it in the downloads section really but hey! just rename the file to *.dxf and it will work. You may need to edit it to your requirements, since the mounting olts are a tight fit, unless you are bolting from behind. Hope it helps :)
Oh yeah, it is in imperial measurements, so you should change that too!