PDA

View Full Version : Looking for post processor



twicecustom
10-28-2008, 09:15 AM
Hello, Im looking for a post processor for my Okuma LC-20 with OSP-5000L-G I'm running Mastercam. Any help will be great.

littlerob
10-28-2008, 02:06 PM
CNCsoftware.com should be able to help, Robert

throttle_jockey
10-31-2008, 12:27 PM
If the machine has IGF you'll want to use that instead of Mastercam. Cleaner code and your timing codes will be easier to organize, as you can sync the turrets right there in IGF. If not you'll want to be really careful when you do simultaneous turning, make sure that the P codes are right and the appropriate turret is selected to be dominant. If it does have IGF and you don't know how to use it contact your local Okuma dealer for some training. It's super-simple to use once you have the basics. If you distributor doesn't do IGF training or they don't know how to use the original IGF on the 5000 control I'd be happy to help you.