PDA

View Full Version : Problem A axis on MHP Hydrapath III



jwgooden
10-16-2008, 12:30 PM
I have a rotary table on this machine that I never use nor will I ever use on this particular machine, and it gives me fits on start ups by not homing out.

I want to remove it from the machine and get rid of it.

I'm assuming I unplug from a board. Do I then remove the board, and also I need to know if there is a parameter or setting in the control I need to shut off?

I'm just not very familiar with these controls and all I use the machine for is drilling and tapping.

Any help would be great!! Thanks