PDA

View Full Version : Millplus question.



suckerdave
10-15-2008, 08:44 AM
I have a 1997 version of millplus running on my DMU 80t. We recently had a lightning strike that took out the processor. I had that repaired. I then began inputting the machine constants into the machine. I put a wrong # in the file and now the software is hung up. When millplus boots up I get a "Divide error on 80486" and the constant that was entered wrong is displayed. I can't edit it from the keyboard. The machine displays the error than reboots the millplus software. I've tried everything I can think of to clear this. DMU claims there is a .CM file on the hard drive that has to be replaced in order to clear this error. I can't find that file of any other program file on the hard disk.
Any help here would be greatly appreciated.

jbojan81
11-09-2008, 10:15 AM
here is my e-mail: jbojan81@yahoo.com
send me what you got, i think i can help you

solidcamx
01-27-2014, 07:12 PM
http://www.cnczone.com/forums/solidcam/209244-dmu50_5x_millplus_solidcam.html#post1425798