PDA

View Full Version : Timming belt help



WeCheat
10-17-2004, 02:55 PM
Need a little help on a timing belt. Have inclosed a link to a photo of the timing belt and need to know what kind it is and were I can buy it. I built a plotter / engraver with parts I could scrounge up and now I would like to enlarge it but need to find a supplier of this kind of belt. Have emailed several companies but have gotten no where with it.
Thanks for your time
WeCheat
http://WeCheat.com/belt.jpg

Al_The_Man
10-17-2004, 03:34 PM
Sterling Instruments (Stock Drive Products) stock 2.03mm pitch which is close to 1.95mm belts and pulleys.
Al

Al_The_Man
10-17-2004, 03:54 PM
BTW, looking at your drawing again the belt width looks more like 6mm? maybe it is 2.03 pitch?
Al

HuFlungDung
10-17-2004, 05:22 PM
Maybe post a pic of the view across the ends of the teeth. There are a few different profiles around.

WeCheat
10-18-2004, 12:16 AM
Thanks for the quick replies!! You gave me a good start on where to look. I will try Stock Drive Products and see what they say. Thanks for your help.