PDA

View Full Version : Newbie stepper voltage



bbrown2005
09-14-2008, 08:53 PM
i have just got a kl34h280-45-4a and a kl-23h2100-30-4bm and was wondering what voltage these work best with and what is the max voltage? also about what is the top rpm they perform brst at thanks

automationtechinc
09-16-2008, 02:15 PM
i have just got a kl34h280-45-4a and a kl-23h2100-30-4bm and was wondering what voltage these work best with and what is the max voltage? also about what is the top rpm they perform brst at thanks

For kl34h280-45-4a and a kl-23h2100-30-4bm , you can use the power supply up to 80 DVC. The speed is up to your driver, power supply and setup in your control software
www.kelinginc.net

bbrown2005
09-16-2008, 08:53 PM
the nema 34 motor is run with a g201 the nema 23 motor is run with kl4030 i have a 36 volt power supply

bbrown2005
09-19-2008, 08:20 PM
i have it up and going and my nema 34 motor aint got as much torque as the 23 motor i have my current set to 5 amps on the 34 motor the motor temp runs about 128 degrees farenhieght when im running it but i can turn the motor without any effort i double checked my current set resistor with dvom to make sure it is the right size. any sugestions thanks ben