PDA

View Full Version : Deckel GNC-1



Dirkos
07-29-2008, 11:18 AM
Hello.
I just got a Deckel GNC-1 without a spindle.
I want to convert it to a milling machine with Mach 3.
There are two books with the machine: one programming book and one general book.

My question is: Does anyone knows what kind of cnc code this machine uses?
There is an Siemens plc in it.

Does anyone knows where to get (a) eletrical diagram(s) ?
I prefer to use the machine with the original servodrivers.

With kind regards,

Dirkos

burnzy
09-02-2008, 07:08 AM
I Have some info on dialog 4 controller