PDA

View Full Version : I need IGF manual or pdf for okuma LB15



cncldwms
06-23-2008, 10:31 PM
I need help using okuma IGF programming on a osp5000 G-L LB15

I need to write a small program for a second operation.

Face to over all length and match bore ID and chamfer at end of part.

**********************************************************

process 1 Rough face over all length

process 2 Finish face O A L

process 3 Rough bore I D

Process 4 Finish bore I D with 45 chamfer @ face or start point

siva.cncmech
10-15-2012, 07:42 AM
hi need help want okuma LT15 OSP 7000L program manual,plz

Drewbert
10-24-2012, 09:04 AM
Process one rgh face part down Ref pt x = raw od size+.100 z= amount to b faced off to get oal
St pt x = raw material size z= 0
End pt x= 0 ( or if a hole is n the part go .100 below the hole size)
Note: b sure to leave stock in z to finish face an nothing n x i usually run this at about .05 depth of cut .008 feed and 450 depends on material and how far its stickin out

Drewbert
10-24-2012, 09:20 AM
Process 2 fnh face create process 2 input all info rough copy process 1 and make sure stock left is 0
Process 3 rgh id< ref pt x =Drill hole size z=.100
Start with a taper it will make more sense to u when u start cuttin diff angles then 45's
Taper/ st pt x=finished id size + double chf size (ex id bore is 2.0 an they want 45x.060 so its 2.0+..120) z=0
End pt x= finish bore size (from ex^ 2.0)
Z end pt leave blank
Z angle 180+45 ( i it was a 60dgr comin off the 180 plane it would b 180+60 this only on the id if u were on the od it would b a 180-45 etc only if it the angle comes off 180 plane)
The lOng< z end pt how ever far u need to go
Leave stock in z and x