PDA

View Full Version : Using work on selected faces problem



BJ-DEKA
06-10-2008, 11:05 AM
Hi all,

I have recently been having some trouble with Solidcam calculating tool paths and was wondering if anyone else has experienced this or had any tips or tricks.

When I try to calculate a tool path using work on selected faces sometimes it will calculate down to 0 then hang up. When it hangs up I can not cancel out of the calculation either. In the task manager it says the program is still running but I have tried letting it sit over night and its still hung up and the only way out is to end program in the task manager.

Anyone had anything like this?

Thank you,
BJ