PDA

View Full Version : Setting up tool changer on a Okuma Howa



69owb
06-07-2008, 09:43 AM
Hi
Can any body tell me how to Set up the tool carausel on a Okuma Howa Millac 5va. It has a Fanuc 6m control and a key pad below the tool carausel that you program in to tell witch tool is in what location. I've been playing with it for a week now and I haven't been able to figure it out yet. Thanks

SINUMERIKO
09-18-2008, 01:59 PM
DO YOU STILL NEED THIS INFORMATION? I JUST HAPPEN TO BE PUTTING BACK TOGETHER A MACHINE JUST LIKE THE ONE YOU MENTION, IT HAS THE ATC PROCEDURE PAPERS ALMOST COMPLETE. IF SO, DROP ME A LINE.

asuratman
08-31-2009, 09:47 AM
Hello SINUMERIKO,
Can I get any information about ATC procedure on how to Set up the tool carausel on a Okuma Howa Millac? I have been working around for them more than weeks but no succeed. Thanks. Aristo.

SINUMERIKO
08-31-2009, 12:43 PM
Hello Asuratman,

What model of Millac do you have?

asuratman
08-31-2009, 08:26 PM
Hello,
I actually have Okuma & Howa Millac 5C 1986 with Fanuc 6MB that might have the same operation on ATC catridge as millac 5V. Now, I am still redressing all hydraulic seals. Thanks. Asuratman.

Rogap
10-17-2014, 09:43 PM
I have he same machine with this problem, coul you help me with the atc procedure?
thank you.

Asesino
02-12-2015, 07:00 PM
Hi SINUMERIKO i have the same problem ....The machine is OKUMA & HOWA MILLAC 5VA FANUC 6TB ...Thanks in advance for your HELP !!!:)

CesarI
02-14-2015, 11:37 AM
Hi i have the same problem ....The machine is OKUMA & HOWA MILLAC 5VA FANUC 6TB ...Thanks in advance for your HELP !!!