PDA

View Full Version : steps Calculator



slp_prlzys
08-19-2004, 09:18 PM
Hello ppl of the Zone.

I found this (http://www.timgoldstein.com/cnc/StepPerIn.asp)
I'm not sure if it's already been posted, but here it is anyway.

Mhel

marvinstov
08-19-2004, 11:11 PM
Cool!

Konstantin
04-26-2005, 07:50 PM
I am trying to calculate my steps per centimeter or millimeter.
Because my lead screw is 19mm per turn, and translating it to TPI (turns per inch?) is like 1.33684210526315789473684210526316 .


Is there any know calc like that but for millimetrics?
I am trying to get as much exactness as possible, might do it by hand after all.




Konstantin.

ls7corvete
04-26-2005, 08:02 PM
what is a good number to have for "steps per inch"?

truman
04-10-2006, 10:39 AM
what is the formula for calculating this you could set it up in exel or something

jcc3inc
04-10-2006, 02:13 PM
Konstantin,

If you have 19mm/revolution and use microstepping (10x), you will have 19/2000 mm/step. This amounts to .0095 mm/step, or .000374 inches per step. This seems like a reasonable distance per step. Depending upon your application's need for speed, a stepping rate of 25 KHz will result in a speed of 561 IPM; good for plasma use.

Regards,
Jack C.

Carel
04-10-2006, 02:24 PM
When I see 19 as a metric value, I get an itchy feeling. 16 or 20 is more used. And yes (25.4 / 4) * 3 = 19.05. So it looks more logical that Konstantins pitch = 3/4 inch.

Carel