PDA

View Full Version : How to use a VFD to convert Milltronics Partner iv to 1ph



ozturbo
03-22-2008, 05:21 PM
I have a Milltronics partner IV with centurion IV that I would like to convert to single phase power. From what I have read, every thing but the spindle motor uses a transfomer to go from 220 to 110v. If I get a new plug for the power that is single phase 220 will everything still work when I power it up, or do I run the chance of blowing the controller? Also, can I just plug the vfd directly in behind the motor or does the power plug into it and the output connects to where the original 3 phase was wired? Thanks