PDA

View Full Version : centering problem



settingbur
03-06-2008, 10:02 PM
When centering machine (F20) an dthen using g0w-2.5 cod to put machine at -63.50 and begin to run production cycle after the first cycle instead of returning to -63.5 it returns at -64.008. Why is it doing this, and how can I prevent this. Thanks

cogsman1
03-07-2008, 06:37 AM
Do you have any "G50" commands in the program that you are NOT canceling correctly? That is usually the problem when that is happening.

settingbur
03-07-2008, 07:47 AM
Do you have any "G50" commands in the program that you are NOT canceling correctly? That is usually the problem when that is happening.
I will take a look at that tomorrow, was editing program yesterday so I may have inadvertently deleted one of those G50's thank you.