PDA

View Full Version : Simple switch for 2 controllers



jubee
02-23-2008, 11:29 PM
Hi All,

Anyone out there in the know if there is some way ,by the means of a simple 2 position switch that can control 2 controllers,one at a time.

I have a simple DSP hand controller that attaches to a card,which provides the ,step/direction, spindle on/off ,and home positions ,which is very easy to use for simple jobs but very limited,however I would like to keep this setup,
Also I have a GREX G100 operating under Mach3 and would also like to keep this setup,

So is there any electronic board or switch that I can attach both the DSP and G100 signals to and be able to switch from one to the other.

Any help or ideas would by great.
Thanks
Regards
Jubee

CarlosC
02-24-2008, 01:44 AM
I can't help with the switch.
Do you have a link to the dsp controller?

jubee
02-24-2008, 02:23 AM
No I dont have a link as it came with a Chinese Router I bought.
I can send a photo of the hand held controller and card if that helps
Regards
jubee