PDA

View Full Version : Maho MH 2000



jalil
02-12-2008, 08:13 AM
HI,Can anyone help me? we can't transfer Gcode file to CNC432 (MAHO 2000) because machine give an error D41(read in/read out device not ready) please advice me.

also hlpe me about amount baud rate, parity, handshaking, etc.

Thanks,
JALIL

thebodger@roger
02-12-2008, 07:54 PM
Press the "help" softkey on the control panel. This will tell you what D30 means. If you still can't figure it out, please post what the D30 error states.

solid sender
02-15-2008, 09:28 AM
Hi Jalil.
Have a look at the following thread, there is some information on handshaking.

http://www.cnczone.com/forums/showthread.php?t=51416&highlight=maho

jalil
02-17-2008, 08:04 AM
HI,Can anyone advice me? I have a problem in transfer Gcode file to CNC432 F700(maho MH2000),machine after receiving 10 or 12 line Gcode give an error D40(baut rate error) but for receiving form cnc to pc no problem. please if possible help me.

baud rate 2400, parity,even 7,1 handshaking,rts/cts etc.

dmelacom
06-19-2008, 01:01 AM
HI,Can anyone advice me? I have a problem in transfer Gcode file to CNC432 F700(maho MH2000),machine after receiving 10 or 12 line Gcode give an error D40(baut rate error) but for receiving form cnc to pc no problem. please if possible help me.

baud rate 2400, parity,even 7,1 handshaking,rts/cts etc.

Karl riehs is the maho doctor. He can help you or sure.

www.MahoDoctor.com