PDA

View Full Version : DIY 3 phase converter



blackbeard52
01-14-2008, 11:10 PM
A few years back I purchased a 3 phase milling machine and did not have 3 phase power. A old machinist guy I knew built me a converter out of a 1 HP 3 phase motor and 3 phase disconnect. I have used it ever since and the more I use it the greater it works.

Al_The_Man
01-14-2008, 11:42 PM
There are many RPC posts here on the subject and many other sites for the DIY'er.
Al.

blackbeard52
01-16-2008, 10:46 PM
OOps

Sorry for the reply... thought it might be of use....I wil retract it of course

Bob