View Full Version : M function feed hold tell switch trips?

11-28-2007, 11:33 AM
I`m working on a retro on a shaper and need to get the Z axis to hold on a M function until it gets to the back of the stroke and then feed down in Z when it trips a switch and then hold until the switch is hit again.

how would I go about setting up turbo cnc to do this?
is it as simple as hooking up one of the inputs to the switch and then just using a M1 ?


11-28-2007, 12:34 PM
after looking at there website it looks like there ZBreak might do it?