View Full Version : Stray lines in SheetCam?

Joe Petro
10-27-2007, 10:53 PM
This is a wierd problem...

Here is a sample of the drawing and SheetCam result.

The issue is when I hide lines by putting them on a layer that is not visible.
After I delete that layer, the lines are gone on the DXF, but still appear in SheetCam. They are tied to layer 0...


Joe Petro

Joe Petro
10-28-2007, 12:28 AM
I figured it out!
Pesky splines! I had to explode them first.

This isn't the first time I have been burned by splines...

Joe Petro