PDA

View Full Version : Does anyone have a tap?



cncadmin
06-01-2004, 06:07 PM
I need a 15/16-16 tap to tap out 3 holes, does anyone have one laying around for me to borrow or a cheap place to buy one?

marvinstov
06-01-2004, 09:28 PM
Paul,
I have one you could borrow. Only used once, practically new.

Marv

cncadmin
06-01-2004, 10:22 PM
Thank you sir!

Cold Fusion
06-05-2004, 11:37 AM
Anyone have a 12-24 tap? I need one for 2 holes.

trubleshtr
06-06-2004, 06:03 PM
Consider grinding a 12-24 bolt on 4 sides all the way up the threads to the head(for chip breaking and chip removal), taper the first third of the bolt for ease of starting the tap., instant tap/thread chaser. Feel free to harden it after if you have a torch and oil handy, don't forget to temper....;D

good luck