PDA

View Full Version : Remnant Modeling and Tooling Board?



composites
10-09-2007, 07:01 PM
Can anybody reccomend a supplier of remnants or smaller sizes of high density tooling board? I make really small molds in small numbers so I don't need a full sheet at a time. I've gotten a couple of quotes from different suppliers and can't seem to come up with anybody that will sell less than a full sheet. Some direction would be appreciated.

Pres
10-10-2007, 05:34 AM
If the density and small size(s) are flexible for you,
consider a sampler pack from:
www.freemansupply.com

They are around 2"x4"x1" - about 6 pcs.(iirc) @$20.

HTH,
Pres

dpryor
10-10-2007, 07:25 AM
We have scraps all of the time. Where are you located and what size are you looking for?

composites
10-11-2007, 07:38 PM
dpryor- I am in Fort Collins, CO. I could use pieces any size down to about 2" wide. Of course some larger pieces would be nice too! I am pretty flexible so if you have some scrap, I would be willing to take it off your hands.