PDA

View Full Version : Deep Groove Taig machine would it be a good starter machine



Fritzie15
09-20-2007, 10:37 PM
Looking to get into CNC machining and was wondering if this would be a good machine to start off with. I look into others like the X3 SYIL cnc but it ways to much to be moving around since i move every 3 months. If you need to take a look it is at this website.

http://www.deepgroove1.com

All i will be doing is aluminum, wax so that i can reuse it etc. Nothing fancy yet

Also what is the accuracy on these types of machines? Will it be close to .001

thanks for all the help

Kevin