View Full Version : Comtrol Controllers?

04-12-2004, 09:52 PM
Has anybody heard of Comtrol. I have a quad cable pci serial controller. Cna this be used to control axis of a machine?

04-13-2004, 02:25 AM
That is a serial port replicator. It basically just adds a collection of serial ports to a computer.

04-13-2004, 03:25 AM
If that is the board i think it is it should also optickly isolate the I/O.
with a bank of diods protecting the power sorce.
not quite as good as a dual powersorce board but dam close.

04-13-2004, 04:55 AM
is there software that could run an axis off each of the ports?Simultaneusly? 1 port per axis?