PDA

View Full Version : Post processor for Solidcam



Eatonbrayer
12-30-2018, 01:47 PM
Can any one offer a post processor for Solidcam 2017. Tried everything I can find without success. Been searching for 2 months.

PlanetCNC
12-30-2018, 01:58 PM
I made it and it will be published with next TNG version.

Eatonbrayer
12-31-2018, 01:43 AM
Wonderful news! - Will it be long before you issue the next version? I see you have suggested this February.

Eatonbrayer
12-31-2018, 01:10 PM
Be very happy to beta test it for you!

PlanetCNC
12-31-2018, 06:26 PM
Please contact our support. They might send you non tested version.