PDA

View Full Version : weldon flats?



cncwhiz
05-08-2007, 07:19 PM
Does anyone have the specs for weldon flats? I need to put them on a solid model. We need these on the print to send to the porting tool manufacture. I know that they allready know the specs for the flats but we need to have them on the print for ISO.

Thanks
Cncwhiz

cb1
05-08-2007, 09:14 PM
ya, i've got the specs.
i don't know how to post them pm me and i'll e-mail them to you.
you can get them out of machinest handbook too. but it's not complete.
i have the spec sheet from the weldon tool co.
i'll scan the spec sheet and post it here tommorrow (if i can figure it out)
then it will be here if anyone else needs it.

cb1
05-09-2007, 05:34 PM
here are the specs for weldon flats.
hope this helps
but please note: there are different sizes for stub length endmills
which are not on this sheet.

cncwhiz
05-09-2007, 06:21 PM
cb1,
Thanks for the info. I looked at your previous posting and went to "weldon" and downloaded their product catalog in pdf. It has the weldon flats listed and a chart by size. Do you want me to attach or pm you the pdf? Thanks for the info.

cncwhiz

cb1
05-09-2007, 09:27 PM
you should post it so if someone else ever needs it, its there.
thanks.

cncwhiz
05-10-2007, 11:13 AM
I am trying to "upload" the file for everyone's use. It is telling me that it is complete but does not show up?