PDA

View Full Version : soft limit system movement aborted



sksmdt
11-25-2018, 07:41 PM
Mach 3 stopped mid cut and the only thing I noticed was the single Blk Alt N light was flashing. I have full movement around the table just jogging it but it will not fire when I try and run a file. I tried several patterns I know that work Mach3 said it was jogging to starting point (which it didn't move) and then nothing. The message line said Softlimits System Movement Aborted. It had cut all but the last 2 inches of a busy pattern when it just stopped. Thanks for any ideas you can toss my way.