PDA

View Full Version : thoughts on a model 425



Greg 24
04-24-2007, 02:45 PM
The shop I work at is looking at -2- model 425 mills to replace our worn out bridgeport manual mills. My question is, does anyone have any thoughts (good or bad) with these mills? I can not tell what control it has, but it looks to me like a DynaPath or Fanuc control. I only have a picture (far away) so it is hard to tell for sure. Any thoughts will be helpful.

Thanks,

RICHARD ZASTROW
04-25-2007, 03:20 PM
Greg, Are these used or new machines?
add: You might want to look at this site www.beavercnc.com They now sell Tree Journeyman J-425 and other models. The new machines have Dynapath Delta 2000M Bandit and Anilam 4300 controls. They say they source parts from "The world market". Good Luck.

Greg 24
04-25-2007, 06:04 PM
These are used machines setting @ a shop that is going on the auction block in Jackson,TN on 4/27. Thanks for the link, that really helped.