PDA

View Full Version : Mk3DRV Upgrade Help



tommyb43
05-17-2018, 03:22 PM
Hi Folks I have just purchased an Mk3DRV

I need help with the wiring of this board to replace the Chinese clone in my 6090
any help would be appreciated
I did send an image of the controller when asking about the upgrade
and the upgrade instructions on Planet CNC are for the older control box

Regards Tom

tommyb43
05-19-2018, 07:40 AM
OK got this installed and working Thanks to Planet CNC Tech Guys :)

Next Question Stepper Current I Have 4 57 two-phase 3A 150N.cm Steppers and work well
The Board Gets Very Hot and i am a little concerned if the on-board Stepper Drivers are being over worked
The Case has its own Drivers can these be used instead of the boards drivers ?

PlanetCNC
05-22-2018, 05:36 AM
You could lower driver current value in settings: File/Settings/Motor Drivers -> Current

tommyb43
05-22-2018, 11:03 AM
You could lower driver current value in settings: File/Settings/Motor Drivers -> Current

Now it won’t recognise the controller and driver is latest one installed


Sent from my iPhone using Tapatalk