PDA

View Full Version : Need Help! Fusion 360 post for G&L 18T with G&L 8000B controller



scsfxguy
05-03-2018, 12:28 PM
I recently started using Fusion 360, and have found posts that run in all the machines in the shop, with the exception of the G&L. I have been in contact with Autodesk trying to get a post that works. I have had no success in finding one. I have "tweeked" the post I have with good results, with the exception of circular interpolation. The controller does not recognize "R" for G2 or G3, so "I" and "K" is what it uses. I always get the error “CIRCULAR MODE PROGRAMMING ERROR”.
Thanks for any help I can get!!